Basic Vinyl Car Wrap Information
In order to properly install a vinyl car wrap, you must have a certain level of knowledge and skill about it. Typically, the job requires more than one person. Getting the design that you want placed on your car with the use of a vinyl car wrap involves getting your car ready for this car wrap first and then using the right tools to effectively put the wrap on the exterior of your car. Leaving this job to the professionals is one of the safest ways to get the job done.
And yet, if you think that you have what it takes to carry on the process then you can do so and even make a business out of it if you are into car detailing and cars in general. You just need to be trained in order for you to apply your vinyl car wrap properly.
No matter if you are doing the installation or have the professionals be the one to do the job, it is important that you should only consider getting vinyl car wraps that are of high quality. Before any design of these car wraps is done, images of the vehicle is a must. You must make sure to consider this factor so that whatever design elements you have in store, they will just fit your vehicle just right. Usually, car detailers will be using the natural lines of your car for the design process. For coverage of overlaps, the use of door panels is a good thing.
Using some water and soap to clean your car is a must to get your car prepared for these car wraps. The drying process after cleaning should be done for one whole day or the entire 24 hours. After your car has been dried appropriately, degreasing must next be done. During this process, some isopropyl alcohol can be used or the use of a panel wipe that is fast drying can also be done.
Waiting for 48 hours for the outgas process to finish at least is another requirement when solvent printed media is used instead for this particular process. Rolls should be kept standing on a vertical position. The process of degassing is very much important to allow the graphic design to be fitted perfectly to the model and shape of your car as well as able to stick on them properly with the use of the right adhesive.
Cold rollers are often used during the lamination process. It is not a good idea to be applying too much tension on the rollers. Using a hard squeegee may be the perfect tool for effective application of a velvet strip. So that your car will not bear a lot of scratches, the velvet should be changed regularly. According to the experts, it would be easier to apply the vinyl car wraps by starting with the flat parts of the panel and then working towards the sides.